Step One
First press the cam fitting into the hole in the panel. Make sure that the small arrow of the cam fitting is pointing toward the hole in the edge of the board.


Step Two
Press the cam down firmly.


Step Three
Install any dowels in the panels as indicated in the assembly instructions.


Step Four
Now screw the connecting bolts into the holes in the matching panel.


Step Five
The connecting bolt should be screwed all the way in so that the flange on the bolt touches the board.


Step Six
Fit the two boards together. Make sure that the head of the connecting bolts goes up inside the cam fitting.


Step Seven
Tighten the cam fitting by turning it in a clockwise direction


Step Eight
Check that the cam fitting has turned between ⅓ and ½ of a revolution.